Miele PT 5136 Installations Plan
Hide thumbs
Also See for PT 5136:
- Operating and installation instructions (68 pages) ,
- Operating and installation manual (56 pages) ,
- Installations plan (13 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele PT 5136
Summary of Contents for Miele PT 5136
-
Page 1: Installation Plan
Installation plan Tumble dryer PT 5136 PT 7136 en - GB To avoid the risk of accidents or damage to the machine, it is essential to read operating and installation instructions before installation and commissioning This prevents both personal injury and damage to the machine. - Page 2 Legend: Connection optional or required, Connection required depending on model Vented Cooling air Condensate drain hose Equipotential bonding Machine anchors Peak-load connection Electrical connection Box plinth Machine feet, adjustable Open plinth Payment system WTV Washer-dryer stacking kit Payment system connection Communication module Cooling air Air intake...
-
Page 3: Machine Dimensions
PT 5136/7136 en - GB Machine dimensions 10 145 460 / 01... - Page 4 - GB PT 5136/7136 Installation 10 145 460 / 01...
-
Page 5: Washer-Dryer Stack
PT 5136/7136 en - GB Washer-dryer stack 10 145 460 / 01... - Page 6 - GB PT 5136/7136 Installation 10 145 460 / 01...
- Page 7 PT 5136/7136 en - GB Installation 10 145 460 / 01...
-
Page 8: Technical Data
- GB PT 5136/7136 Technical data PT 5136 PT 7136 Drying system Vented Vented Drum volume Load capacity Door opening diameter E l e c t r i c a l c o n n e c t i o n ( E L ) - Page 9 PT 5136/7136 en - GB Technical data PT 5136 PT 7136 Standard voltage 13A (GB only) 1N AC 220-230 V Total rated load 2.76 – 2.99 Fuse rating (B trip rating according to EN 60898) Supply lead min. cross-section mm²...
- Page 10 - GB PT 5136/7136 Technical data PT 5136 PT 7136 Standard voltage (CDN only) 3 AC 208 V 3 AC 208 V Frequency Total rated load Fuse rating 3 x 30 3 x 30 Supply lead min. cross-section mm²...
-
Page 11: Options & Accessories
Rawl plugs (diameter x length) 8 x 40 8 x 40 Anchoring of Miele plinths Miele plinth installation (fasteners included) Required anchor points Wood screws according to DIN 571 8 x 65 8 x 65 Rawl plugs (diameter x length) - Page 12 If converting the machine to an alternative voltage, observe the site or using a kit available from Miele Spares. instructions in the wiring diagram. Conversion must be performed by an authorised agent or a Miele service technician. The heater Peak load/energy management rating must also be properly set.
- Page 13 Washer-dryer stack to the installation footprint via the machine feet. A Miele tumble dryer can be stacked on top of the washer-extractor. A "WTV" stacking kit (optional accessory) is required for this. It is not absolutely necessary to bolt the machine to the floor.