Connecting To The Ac Outlet - Panasonic HDC-SD100 Operating Instructions Manual

Battery capacity indication
p The display changes as the battery capacity reduces.
p The remaining battery capacity is displayed when using the Panasonic battery that you can use for
p The maximum amount of remaining battery capacity able to be indicated is 9 hours 59 minutes. If
p When turning the mode dial to switch modes, the time indication will turn off momentarily in order to
p When using the AC adaptor or batteries made by other companies, the remaining battery capacity
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always
"live" as long as the AC adaptor is connected to an electrical outlet.
Important:
While the DC cable is connected to the AC adaptor, the battery will not charge.
p Do not use the AC cable with any other equipment as it is designed only for this unit. Do not
1
2
3
18
VQT1T90
Downloaded From CamcorderManual.com Panasonic Manuals
If there is less than 3 minutes remaining, then
then ( ) will flash.
this unit. It may take time to display the remaining battery capacity. The actual time can vary
depending on your actual use.
the actual remaining time exceeds 9 hours 59 minutes, the indication will stay green and will not
change until the remaining time falls below 9 hours 59 minutes.
recalculate the remaining battery capacity time.
will not be shown.

Connecting to the AC outlet

use the AC cable from other equipment with this unit.
DC IN

DC output terminal
DC input terminal
Insert the DC cable so the [
terminal.
Connect the AC cable to the AC adaptor and the AC outlet.
Connect the DC cable to the AC adaptor.
Connect the DC cable to the DC input terminal [DC IN].
will become red. If the battery discharges,
] mark is pointing upward matching the [
 
] mark of the DC input