InMotion R1XX series User Manual page 64

29 Wi-Fi Error
31 CAN Error
32 Sensor Error
33 Excessive Angle
34 Excessive Speed
35 Locked and move
46 Battery Access
Error
47 Battery Discharge
Error
49 Low Battery
Voltage
62 Abnormal Motor
Wi-Fi is not set up properly or the
INMOTION SCV cannot get an IP address.
Electric Circuit Failure
Sensor Failure
Excessive angle due to road conditions or
other reasons when the INMOTION SCV is
in Balance Mode
Excessive Speed when the INMOTION
SCV exits Balance Mode
The angle or the position has changed while
the INMOTION SCV is in Security Mode
You are not using an INMOTION Battery
Pack, or Battery failure
Battery Failure
Battery voltage is too low
Motor temperature or environmental
Reset your Wi-Fi, and restart the INMOTION SCV
Contact INMOTION Customer Care at
service@imscv.com
Contact INMOTION Customer Care at
service@imscv.com
Ride the INMOTION SCV following instructions. See
page 10 for Max Climbing Angle.
Reduce speed before stepping off
Move or use the INMOTION SCV only after it is
unlocked
Use only the INMOTION Battery Pack. In case of
Battery failure, contact INMOTION Customer Care at
service@imscv.com
Contact INMOTION Customer Care at
service@imscv.com
Recharge the Battery Pack
Stop using the INMOTION SCV and let it rest.
64 / 68