InMotion R1XX series User Manual page 15

Assembling the INMOTION SCV:
1. Insert the Handlebar into the top of the Turning Shaft (the slimmer part), and tighten the Screw using the Installation Tool.
The Screw and Installation Tool are included in the box. Please pay attention to the front and back of the Handlebar.
2. Unlock the Quick Release Lock, insert the Turning Shaft into the Pivot Base Assembly until you feel resistance, and lock
the Quick Release Lock. Please note, if the Turning Shaft is not completely inserted, the Quick Release Lock cannot be locked
properly. Assembly of the Turning Shaft is now complete. When necessary, remove the Turning Shaft from the SCV by unlocking
the Quick Release Lock.
3. Remove the Battery Pack from the battery package, lean the INMOTION SCV body forward, and hold it steady. Slide the
Battery Pack into the Battery Slot. When you hear a click, gently try to pull the Battery Pack out. The Battery Pack is installed
properly if it cannot be removed without releasing the latch.
4. Press the Reset Button on the back of the SCV, and power on the INMOTION SCV using the SmartKey.
If necessary, especially when you need to put the INMOTION SCV in the trunk of your car, the Turning Shaft and the
Handlebar can be quickly removed by unlocking the Quick Release Lock.
Please confirm the Turning Shaft is installed properly. Try lifting the Turning Shaft with both hands to check if it is loose. If it
is loose, tighten the Screw.
If you need to remove the Turning Shaft, hold it tightly with one hand, unlock the Quick Release Lock, slightly shake it and
then pull it out.
15 / 68