Error Messages; Common; Dvd - Panasonic DIGA DMR-E75V Operating Instructions Manual

Helpful Hints

Error messages

∫ Common

Operation
X HOLD

∫ DVD

On the TV
Cannot finish recording completely.
Cannot record on the disc.
Please check the disc.
Unable to format.
Cannot record. Disc is full.
Cannot record. Maximum number of titles
recorded.
Error has occurred. Please press ENTER.
Timer Recording standby or Ext Link
standby will be canceled.
No Disc
Please change the disc.
This is a non-recordable disc. Cannot record. ≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized
This disc is not properly formatted.
Formatting is necessary using DISC
MANAGEMENT.
On the unit's display
HARD ERR
NO READ
PROG FULL
REMOTE MODE ∑
("∑" stands for a number.)
SLF CHECK
U59
U99
UNSUPPORT
66
≥The Child Lock function is activated.
Press and hold [ENTER] and [RETURN] simultaneously until "X HOLD"
disappears.
≥The programme was copy-guarded.
≥The disc may be full.
≥The disc may be dirty or scratched.
≥Create space by erasing any unnecessary titles. [RAM]
≥Use a new disc. [RAM] [DVD-R]
≥Press [ENTER] to start recovery process. You cannot operate the unit while it is
recovering ("SLF CHECK" appears on the unit's display).
≥The disc is upside down.
≥There may be a problem with the disc. Press [< OPEN/CLOSE] on the main unit
to remove it and check it for scratches or dirt. (The unit turns off automatically
after you open the tray.)
DVD-R.
≥You inserted an unformatted DVD-RAM. Format the disc with this unit.
≥The operation is prohibited by the unit or disc.
≥If there is no change after turning the unit on and off, consult the dealer where the
unit was purchased.
≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.
≥You have used a DVD-RAM/PD lens cleaner and it has finished.
Press [< OPEN/CLOSE] on the main unit to eject the disc.
≥There are already 16 timer programmes. Erase unnecessary timer programmes.
≥The remote control and main unit are using different codes. Change the code on
the remote control.
≥The unit is starting up. Wait until the message disappears.
≥The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until
the message disappears.
Select a position with good ventilation when installing the unit. Do not block the
cooling fan on the rear of the unit.
≥The unit fails to operate properly. Press [Í/I] on the main unit to switch the unit to
standby. Now press [Í/I] again to turn the unit on.
≥You have inserted a disc the unit cannot play or record on.
DVD
Press and hold [ENTER] and the
indicated number button at the same
time for more than 2 seconds.
VHS
Page
62
Page
–
17
29, 31
–
–
17
17
–
29
–
Page
–
17
–
27, 55
11
–
–
–
15