Table of Contents
Advertisement
Recording
[1]
While stopped
Press [FUNCTIONS].
[2]
Select "FLEXIBLE REC" with [3, 4, 2, 1] and
press [ENTER].
[3]
Press
[3, 4, 2, 1] to
set the
recording time.
≥You can also set
the recording time
with the numeric
buttons.
≥Maximum recording
time is 8 hours.
[4]
Select "Start" with [3, 4, 2, 1] and press
[ENTER].
≥Recording starts.
For your reference
≥It is not possible to change channel or recording mode while
Flexible Recording is paused.
∫ To exit the FLEXIBLE REC window without recording
Press [RETURN].
∫ To stop recording partway
Press [∫, STOP].
∫ To show the time
remaining until recording
finishes
Press [STATUS] several times.
≥It is displayed in the unit of
minute.
Note
≥When performing EXT LINK recording (l right), the flexible
recording function does not work.
Direct TV Recording
This function is not available unless you connect TV and this
unit with the 21-pin Scart cable.
[RAM] [DVD-R]
This function allows you to immediately start recording the same
programme that you are viewing on the TV.
The programme position selected on the unit automatically changes
to that of the TV programme that you are viewing on the TV.
Conditions for the Direct TV Recording function:
≥Your TV must be equipped with the [Q Link] function.
≥The unit must be connected to the TV via a fully-wired 21-pin Scart
cable.
[1]
Insert a disc.
(l 17)
[2]
Press [¥, DIRECT TV REC].
≥Recording of the TV programme that you are viewing on the TV
starts.
[3]
Press [∫, STOP] to stop recording.
Note
≥When you stop recording, the unit automatically switches back to
the previously selected programme position.
(l 49)
FLEXIBLE REC
Recording in FR mode
Maximum rec. time
1 Hour 23 Min.
Set rec. time
1 Hour 23 Min.
Start
Cancel
Select
RETURN
DVD-RAM
Remaining
REC 83
time
ARD
L R
Linked timer recordings with external
equipment (EXT LINK)
This function is not available unless you connect an external
equipment and this unit with the 21-pin Scart cable.
[RAM] [DVD-R]
If an external equipment (for example a satellite receiver) with a
timer function is connected to the AV2 terminal of this unit by a
21-pin Scart cable (l 12), it is possible to control the recording of the
unit with the equipment.
Preparation
≥Change the "Ext Link" in the SETUP menu to match the connected
equipment. (l 45)
≥Timer programming has to be done on the external equipment and
switched to the timer recording standby mode. Refer to the
equipment's operating instructions.
[1]
Press [EXT LINK].
The unit turns off and switches to the recording standby mode.
≥"EXT L" lights on the unit's display.
The timer recording standby mode is activated on DVD
("EXT L" lights on the DVD unit's display). However, the unit
may not be turned off automatically.
≥You can play a DVD-RAM on DVD, play or record any media on
VHS even if the timer recording standby mode is activated on DVD.
≥Recording begins when a signal is received from the connected
equipment.
≥As long as a video picture is being transmitted by the external
equipment, the unit will record it.
[2]
Turn the unit off when you do not play or record
any media on VHS.
≥If the timer recording is started with keeping the unit turned on,
the unit is not turned off automatically even after the timer
recording is completed.
When the following message appears on the television screen, press
[2, 1] to select "Yes" (continue recording the current programme)
or "Cancel" (cancel recording) and press [ENTER].
To cancel the external control
Press [EXT LINK] to stop recording or to cancel linked timer
recording standby.
≥You can also press and hold [∫, STOP] on the DVD main unit for
more than 3 seconds to stop recording.
≥In order to prevent accidental operation, press [EXT LINK] to
cancel the setting after recording is finished.
For your reference
≥The video being recorded automatically appears on the television
when connected to this unit's AV1 terminal with the 21-pin Scart
cable.
≥This function does not work with some equipment. Refer to the
equipment's operating instructions.
≥The beginnings of recordings may not be recorded correctly in
some cases.
≥When "Ext Link" is set to "Ext Link 2", this function does not work if
the input signal is NTSC system. (l 45)
DVD
DVD now recording this programme.
Yes
Cancel
25
Hide quick links:
Advertisement
Table of Contents
