Table of Contents
Advertisement
Reference
Error messages
∫ Common
On the unit's display
H
, F
, U
("
" stands for a number.)
∫ DVD
On the TV
Cannot finish recording
completely.
Cannot play.
Cannot record on the disc.
Unable to format.
Please check the disc.
Cannot record. Disc is full.
Cannot record. The number
of titles has exceeded the
maximum limit.
Error has occurred. Please
press ENTER.
No disc
Please change the disc.
This is a non-recordable disc. ≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R, DVD-
This disc is not formatted
properly.
On the unit's display
RC
(" " stands for a number.)
Err
oooooo
(self check)
U59
U99
∫ VHS
On the TV
No VHS cassette.
Please check write protect
tab on the VHS cassette.
60
VQT0R73
≥An error has occurred. The number following "H", "F" or "U" depends on the status of the unit.
Reset procedure: ("The unit is on but cannot be operated." l 62)
≥If the service numbers fail to clear, note the service numbers and contact a qualified service person.
≥The program was copy-protected.
≥The disc may be full.
≥There are already 99 recorded titles ([+R] 49 recorded titles).
≥You inserted an incompatible disc (Discs recorded in PAL video, etc.).
≥The disc may be dirty or scratched.
≥Create space by erasing any unwanted titles. [RAM] [-RW‹V›]
[Even if you erase recorded content from the DVD-R or +R, there is no increase in disc space. Available
disc space on DVD-RW (DVD-Video format) increases only when the last recorded title is erased.]
≥Use a new disc.
≥Press [ENTER] to start recovery process. You cannot operate the unit while it is recovering
("SLF CHECK" appears on the unit's display).
≥You haven't inserted a disc. Correctly insert a disc that the unit can play.
≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.
≥There may be a problem with the disc. Press [<, OPEN/CLOSE] to remove it and check it for
scratches or dirt. (The unit turns off automatically after you open the tray.)
RW (DVD-Video format) or +R.
≥You inserted an unformatted DVD-RAM or DVD-RW. Format the disc with the unit.
≥The operation is prohibited by the unit or disc.
≥The remote control and main unit are using different codes. Change the code on the remote
control.
≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.
≥You have used a lens cleaner and it has finished. Press [<, OPEN/CLOSE] to eject the disc.
≥You have inserted a disc the unit cannot play or record on.
≥You have inserted a DVD-RAM or DVD-RW that is unformatted or recorded on other equipment.
≥If there is no change after turning the unit on and off, consult the dealer where the unit was purchased.
≥There was something unusual detected with the disc while recording, playing or transferring
(dubbing), there was a power failure or the AC plug was disconnected while the unit was on. The
unit is carrying out its recovery process. This process restores the unit to normal operation. The
unit is not broken. Wait until the message disappears.
The symbol "o" appears at the bottom left of the unit's display. The
number of symbols increases one by one until six appear. They then
disappear one by one until none remain. This continues during self
check.
≥The unit is very warm.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears.
Select a position with good ventilation when installing the unit. Do not block the cooling fan on the
rear of the unit.
≥The unit fails to operate properly. Press [POWER Í/I] on the main unit to switch the unit to
standby. Now press [POWER Í/I] on the main unit again to turn the unit on.
≥A video cassette is not inserted when recording programs. Insert a video cassette with an
accidental erasure prevention tab.
≥A video cassette without the accidental erasure prevention tab is inserted when recording programs.
Use a video cassette with an accidental erasure prevention tab.
DVD
VHS
Page
–
–
Page
–
–
–
–
8
21, 30,
33
–
–
6, 8
8
8
–
31
20
Page
18
8
8
7
31
–
61
–
–
Page
46
46
Advertisement
Table of Contents
