NordicTrack X7i User Manual page 23

SYMPTOM: The walking belt is not centered
between the foot rails
a. IMPORTANT: If the walking belt rubs against
the foot rails, the walking belt may become
damaged. First, adjust the incline to 40 percent.
Remove the key and UNPLUG THE POWER
CORD. If the walking belt has shifted to the
left, use the hex key to turn the left idler roller
screw clockwise 1/2 of a turn; if the walking belt
has shifted to the right, turn the left idler roller
screw counterclockwise 1/2 of a turn. Be careful
not to overtighten the walking belt. Then, plug in
the power cord, insert the key, and run the incline
trainer for a few minutes. Repeat until the walking
belt is centered.
a
SYMPTOM: The walking belt slips when walked on
a. First, adjust the incline to 40 percent. Remove the
key and UNPLUG THE POWER CORD. Using the
hex key, turn both idler roller screws clockwise, 1/4
of a turn. When the walking belt is correctly tight-
ened, you should be able to lift each edge of the
walking belt 3 to 4 in. (8 to 10 cm) off the walking
platform. Be careful to keep the walking belt cen-
tered. Then, plug in the power cord, insert the key,
and carefully walk on the incline trainer for a few
minutes. Repeat until the walking belt is properly
tightened.
a
Foot Rails
23
SYMPTOM: The incline of the incline trainer does
not change correctly
a. Hold down the Stop button and the Speed increase
button, insert the key into the console, and then
release the Stop button and the Speed increase
button. Next, press the Stop button and then press
the Incline increase or decrease button. The incline
trainer will automatically rise to the maximum
incline level and then return to the minimum level.
This will recalibrate the incline system. If the incline
system does not begin calibrating, press the Stop
button again, and then press the Incline increase or
decrease button again. When the incline system is
calibrated, remove the key from the console.
SYMPTOM: The tablet holder does not stay in place
a. Rotate the tablet holder backwards. Then, tighten
the indicated screw slightly until the tablet holder
stays in place when it is rotated to the desired
position.
a
Screw
Tablet
Holder