Table of Contents
Advertisement
Checking PVC Connections
Check PVC connections to verify that all PVCs, including management PVCs, are
configured and active.
Procedure
To verify PVCs:
1. Select PVC Connection Status from the Status menu.
The PVC Connection Status screen shows all PVC connections, the interface
source and DLCI number of the incoming data linked to the interface, and DLCI
number for the outgoing data. You can also see whether the PVC is active.
2. Verify that each PVC is active.
— If active, the router should be passing data.
— If not active, no data traffic can be carried by the PVC. If the PVC is configured
correctly, the circuit may be down.
Provisioning the Router Interface
The FrameSaver DSL Router defaults to bridge mode. Routing without bridging, and
simultaneous routing and bridging, are also options.
Use the bridge command from the router's CLI to configure the bridge and routing
attributes. Also, enter an Ethernet IP address and a DHCP IP address. Refer to the
Quick Reference for a summary of configuration options, CLI commands, and default
settings.
Cables and Connectors
Refer to
Installing the Router
T
The DSL network interface uses an 8-pin
unkeyed modular plug. Use a standard
twisted-pair cable rated at CAT3 or better.
8-Pin
Connector
Pin Number
1–3
4
5
6–8
on page 7 for cable installation information.
Function
Not used
DSL Ring
DSL Tip
Not used
DSL
Cable
Pin #8
Pin #1
22
01-16887-01
Advertisement
Table of Contents
