Table of Contents
Advertisement
Configuring SNMP Trap Managers and Traps
Procedure
To enter SNMP managers and configure traps:
1. Select SNMP Traps.
Main Menu → Configuration → Management and Communication →
SNMP Traps
2. Configure the following:
— Enable SNMP Traps.
— Identify the total Number of Trap Managers.
— Specify the IP address for each NMS Trap Manager to which traps will be sent.
— Specify the Initial Route Destination for each Trap Manager. The default is
AutoRoute.
— Select or disable trap categories, as needed.
3. Save the configuration.
Setting Up for In-Band Management
If FRF.8 Encapsulation Mode is set to Translational, remote management of the router
can still be accomplished in-band, as indicated in the following procedure.
Before you use the following procedure, verify that:
T
The router's Ethernet interface has already been assigned an IP address that is in
the same subnet as the management IP address entered in
Using the Easy Install Feature
T
The router is not configured for bridging only
Refer to Configuring the FrameSaver DSL Router ; CLI Commands, Codes, and
Designations , and Command Line Summaries and Shortcuts in the User's Guide for
additional information.
19
Step 5
on page 18 of
Advertisement
Table of Contents
