Reset Button; Important Information To Read Before Installing; Ethernet Ports; Radios And Antennas - HP msm4 series Installation And Getting Started Manual

MSM320/MSM325

Important information to read before installing

Ethernet ports

The MSM320 has two 10/100 Mbps Ethernet ports with RJ-45 connectors. Port 1 supports
Power over Ethernet (PoE) 802.3af. In controlled mode, Port 1 should be used. In
autonomous mode, Port 1 or Port 2 can be used.

Reset button

 Press and quickly release the button to reset the MSM320.
 To reset to factory default settings, press and hold the reset button until the status lights
flash three times, then release. Following a reset to factory defaults, the MSM320
starts up in controlled mode.
Note
To reconnect to the management tool after a factory reset, your computer must be connected
to Ethernet Port 1.

Radios and antennas

The MSM320 has two radios, each with two antennas for diversity.
The antenna connectors are reverse-polarity SMA jacks. Antennas or cable connectors must
use RP-SMA plugs. Antennas can be mounted directly on the MSM320. When a single antenna
is used per radio, it is recommended to connect it to the Main antenna connector.
Note
Optional external antennas are available from HP.
Important information to read before
installing
For indoor installation only.
PROFESSIONAL INSTALLATION REQUIRED
Prior to installing or using the MSM320, consult with a professional installer trained in RF
installation and knowledgeable in local regulations including building and wiring codes,
safety, channel, power, indoor/outdoor restrictions, and license requirements for the intended
country. It is the responsibility of the end user to ensure that installation and use comply with
local safety and radio regulations.
6-4