Step 2: Connect The Cables And Power On The Msm320-R; Step 3: Switch The Msm320-R To Autonomous Mode; Step 4: Log In - HP msm4 series Installation And Getting Started Manual

MSM320-R
Initial configuration (autonomous mode)
2. Disable any wireless connection on your computer.

Step 2: Connect the cables and power on the MSM320-R

1. Connect the cables:


2. Power on the MSM320-R by powering on the PoE switch or injector. Wait approximately a
minute for the MSM320-R to initialize before proceeding to the next step.

Step 3: Switch the MSM320-R to autonomous mode

Note
A factory-default MSM320-R is assumed.
1. In a Web browser, enter the address: https://192.168.1.1.
2. A security certificate warning is displayed the first time you connect to the management
tool. This is normal. Select whatever option is needed in your Web browser to continue to
the management tool. The security warning will not appear again unless you change the
IP address of the MSM320-R.
3. On the Login page, specify admin for both Username and Password and then select
Login. The MSM320-R management tool home page opens.
4. Select Switch to Autonomous Mode and confirm the change. The MSM320-R restarts in
autonomous mode.
Note
To avoid a delay after switching modes, clear the ARP (address resolution protocol) cache on
your computer. In Windows for example, from the Windows Start menu, select Run and
enter "arp -d" (without the quotes). Select OK.

Step 4: Log in

1. Wait until the login page appears, then specify admin for both Username and Password.
Select Login.
2. On the License Agreement page, read the agreement and select Accept License
Agreement.
3. The registration page appears. It is recommended that you register later by selecting
Maintenance > Registration.
7-12
If using a PoE switch, use standard Ethernet cables to connect your computer and
the MSM320-R to an unused factory-default PoE switch.
If using a PoE injector, use a crossover Ethernet cable to connect your computer to
the data in port of the PoE injector and a standard Ethernet cable to connect the
MSM320-R to the data and power out port of the PoE injector.