Installation; Step 1: Plan The Installation - HP msm4 series Installation And Getting Started Manual

MSM310-R

Installation

Installation

Warning
The MSM310-R must be installed with the antennas pointing straight up. Damage caused by
water ingress through the RJ-45 connector as a result of the MSM310-R being improperly
installed or the improper assembly or attachment of the weatherproof RJ-45 connector, is not
covered by the warranty.
Warning
Corrosive damage caused by salt fog is not covered by the warranty.
The MSM310-R is typically interconnected with other equipment as follows (only the
antennas and weatherproof RJ-45 connector are supplied with the MSM310-R):
Warning:

Step 1: Plan the installation

Identify a suitable install location. The MSM310-R has a NEMA 4 rating and is unsuitable for
installation in a salt fog environment. Local electrical and building codes and regional
regulations will dictate many aspects of your installation. It is recommended that you
perform transmission and reception tests at a proposed location before installing. In some
cases it may be desirable to install remote antennas, off the body of the MSM310-R.
You will have to provide an effective earth ground for the MSM310-R, at least one of its
antenna surge suppressors, and the Ethernet surge suppressor. It is rarely sufficient to use a
metal pole for any equipment grounding. You will also need to decide how to route the
Ethernet cable from the building to the MSM310-R.
5-6
MSM310-R topology
1: Internet
2: Ethernet surge suppressor
3: PoE Injector
➁
This is a general procedure. It is the installer's responsibility to perform the installation
according to local electrical code and regulations.
4: Broadband router
5: Broadband modem
6: Indoors
➀
➅
➂ ➃
➄