Table of Contents
Advertisement
2.1
PACKING CHECK LIST
1 off Canopy / firebox / burner assembly
4 off 8G x 3/8" pozi screws
1 off Flue spigot
1 off DD cover (attached to rear of fire)
1 off Closure plate (attached to rear of fire)
1 off Installation & user manual (combined)
1 off Fender (attached to front of fire)
1 off Guarantee card
1 off Fuelbed
1 off Coal pack
1 off Glass assembly
1 off Fender
1 off Thermostatic remote handset
5 off AA batteries
2.2
INSTALLATION OF FIRE
2.2.1
Preparation.
2.2.2
Remove the glass panel by rotating the latch to release. Lift the glass
panel upwards and lift away. See figure 2.
Fig. 2
Remove the Glass Panel
2.2.3
Grasp sides of the of the glass panel and pull lower edge forward.
2.2.4
Remove the coal / fuelbed packs that have been retained by the glass
panel (not shown in figure 2 above)
2.2.5
To re-fit the glass panel, engage the 2 side glasses in the sealing
channels, with the projecting glass edge uppermost. Slide the panel up
until the top edge enters the slot, then push the lower edge in and turn
the latch to secure it.
9
Glass Panel
Retaining Latch
Hide quick links:
Advertisement
Table of Contents
