Rear Panel Connections - Harman Kardon Digital Lounge HS 250 Service Manual

harman/kardon

Rear Panel Connections

4
7
0 HDMI Output
1 Remote IR Output
2 Remote IR Input
3 USB On-The-Go Input
4 AC Power Cord
5 FM Antenna
0 HDMI Output: Connect this output to the
HDMI input J of the screen, using the supplied
HDMI - SP-DIF - Remote In/Out cable.
1 Remote IR Output: This connection per-
mits the IR sensor in the receiver to serve other
remote controlled devices. Connect this jack to
the "IR IN" jack on Harman Kardon or other
compatible equipment. Note this connection is
only necessary for optional, additional products
connected to the player. It is not necessary for
proper control of the Digital Lounge system.
2 Remote IR Input: Connect this input to the
Remote IR Output U of the TV, using the special
HDMI - SP-DIF - Remote In/Out cable. This will
allow you to control all components in your sys-
tem by pointing the remote control to the TV
only.
3 USB On-The-Go Input: This input may be
used to temporarily connect a USB thumb device
or portable hard disk for direct playback of
audio, image of video files, a digital photo cam-
era or a USB hub.
4 AC Power Cord: Connect this plug to an
AC outlet. If the outlet is controlled by a switch,
make certain that it is in the ON position.
B
D
6 Audio In
7 Subwoofer Output
8 Coaxial Digital Input
9 Optical Digital Input
A Analog Audio Outputs
B Speaker Outputs
5 FM Antenna: Connect to the supplied FM
antenna.
6 Audio In: Connect to a line-level analog
audio source: TV, tape player, Minidisc, PC, etc.
7 Subwoofer Output: Connect to the
SUB/LFE input on the subwoofer.
8 Coaxial Digital Input: Connect the coaxial
digital output from a DVD player, HDTV receiver,
LD player, MD player, satellite receiver or CD
player to this jack. The signal may be either a
Dolby Digital signal, DTS signal or a standard
PCM digital source.
9 Optical Digital Input: Connect the optical
digital output from a DVD player, HDTV receiver,
LD player, MD player, satellite receiver or CD
player to this jack. The signal may be either a
Dolby Digital signal, DTS signal or a standard
PCM digital source.
A Analog Audio Outputs: Connect these
jacks to the RECORD/INPUT jacks of an optional
audio recorder for recording.
Digital Lounge HS 250/230 Service Manual
3 2 1 0
E 9 C 8 A 6
C Coaxial Digital Output
D Subwoofer Trigger Output
E DMP The Bridge Input
F Analog Audio Inputs
B Speaker Outputs: Connect these outputs
to the matching + or – terminals on your left
and right speakers. In conformance with the new
CEA color code specification, the White terminal
is the positive, or "+" terminal that should be
connected to the red (+) terminal on Left
speaker with the older color coding, while the
Red terminal is the positive, or "+" terminal that
should be connected to the red (+) terminal on
Right speaker. Connect the black (–) terminals
on the Digital Lounge system to the black (–)
terminals on the speakers. See page 19 for more
information on speaker polarity.
Note: You'll find more details about all
Audio/Video connections under Setup and
Connections on the following pages.
C Coaxial Digital Output: Connect this jack
to the matching digital input connector on a
digital recorder such as a CD-R or MiniDisc
recorder.
F 5
Page 7 of 56