Fuel - Webasto thermo top e Installation Instructions Manual

Fuel

CAUTION!
Open the vehicle's fuel tank cap, ventilate the tank and then re-close the tank lock.
Catch any fuel running off with an appropriate container.
Install fuel line and metering-pump wiring harness so that they are protected against stone impact. Un-
less specified otherwise, always fasten using cable ties.
Mount the fuel line and wiring harness with rub protection on sharp edges.
WARNING!
The fuel line and wiring harness are routed to the metering pump in as shown in the wiring harness
routing diagram.
1
2
3
1
1314514A_EN
28
29
2 3
30
5 4
Route fuel line 1 , together with wiring harness
of metering pump to firewall on right-hand
side of vehicle and further in line duct on un-
derbody to installation location of metering
pump.
2 Hose section, 10 mm dia. clamp [2x]
1 Fuel line from heater unit
2 Line duct
3 Metering pump wiring harness
1
2
1 Angle bracket
2 Silent block, flanged nut [2x]
3 Rubber-coated pipe clamp
4 Metering pump
5 Original vehicle bolt
Peugeot 3008
Connec-
tion to
heater unit
Installing
lines
Installing
metering
pump
15