Removal/Shifting Of The Master Control Element - Siemens SICAM TM Installation Manual

3.5.1.

Removal/Shifting of the Master Control Element

To remove the master control element again, or to change its position on the TS35 rail, the
spring retainers on the back panel of the housing must be opened.
To do this, one inserts a slotted-screw screw-driver below the housing in the spring retainer

and pushes the screw-driver upwards
held in a slightly tilted position
master control element can be removed or shifted on the rail.
1
After shifting the master control element the spring retainers must be closed again in order to
fix the housing. For this a slight push on the spring retainer
the closed position.
SICAM TM, Installation
DC6-015-2.04, Edition 10.2014
‚.
As a result, the spring retainer opens and is
ƒ
. As soon as both spring retainers are in this position the
3
4
„
is sufficient to bring it back to
Assembly
2
33