Cisco Catalyst 4500 Series Configuration Manual page 1374

Configuring SNMP
Command
Step 3
Switch(config)# snmp-server group
{
groupname v1 | v2c | v3
| ]} [
priv read readview]
[
writeview] notify notifyview]
access-list]
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
60-10
Purpose
Configures a new SNMP group on the remote device.
[ |
auth noauth
• For groupname, specify the name of the group.
[
write
[
access
• Specify a security model:
–
–
–
Note
• (Optional) Enter read readview with a string (not to exceed 64
characters) that is the name of the view in which you can only
view the contents of the agent.
• (Optional) Enter write writeview with a string (not to exceed 64
characters) that is the name of the view in which you enter data
and configure the contents of the agent.
(Optional) Enter notify notifyview with a string (not to exceed 64
•
characters) that is the name of the view in which you specify a
notify, inform, or trap.
• (Optional) Enter access access-list with a string (not to exceed 64
characters) that is the name of the access list.
v1 is the least secure of the possible security models.
v2c is the second least secure model. It allows transmission
of informs and integers twice the normal width.
v3, the most secure, requires you to select an authentication
level:
auth—Enables the Message Digest 5 (MD5) and the Secure
Hash Algorithm (SHA) packet authentication.
noauth—The noAuthNoPriv security level. it is the default if
no keyword is specified.
priv—Enables Data Encryption Standard (DES) packet
encryption (also called privacy).
The priv keyword is available only when the crypto software
image is installed.
Chapter 60 Configuring SNMP
OL-25340-01