Disabling The Snmp Agent - Cisco Catalyst 4500 Series Configuration Manual

Chapter 60 Configuring SNMP

Disabling the SNMP Agent

To disable the SNMP agent, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# no snmp-server
Step 3
Switch(config)# end
Step 4
Switch# show running-config
Step 5
Switch# copy running-config
startup-config
The no snmp-server global configuration command disables all running versions (Version 1,
Version 2C, and Version 3) on the device. No specific Cisco IOS command exists to enable SNMP. The
first snmp-server global configuration command that you enter enables all versions of SNMP.
Configuring Community Strings
You use the SNMP community string to define the relationship between the SNMP manager and the
agent. The community string acts like a password to permit access to the agent on the switch. Optionally,
you can specify one or more of these characteristics associated with the string:
•
•
•
OL-25340-01
An access list of IP addresses of the SNMP managers that are permitted to use the community string
to gain access to the agent
A MIB view, which defines the subset of all MIB objects accessible to the given community
Read and write or read-only permission for the MIB objects accessible to the community
Purpose
Enters global configuration mode.
Disables the SNMP agent operation.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring SNMP
60-7