Configuring Ethernet Cfm Crosscheck - Cisco Catalyst 4500 Series Configuration Manual

Chapter 63 Configuring Ethernet OAM and CFM
Command
Step 25
end
Step 26
show ethernet cfm maintenance-points {local |
remote}
Step 27
show ethernet cfm errors [configuration]
Step 28
copy running-config startup-config
Use the no versions of the commands to remove the configuration or return to the default configurations.
This is an example of the basic CFM configuration:
Switch(config)# ethernet cfm ieee
Switch(config)# ethernet cfm global
Switch(config)# ethernet cfm domain abc level 3
Switch(config-ecfm)# service test vlan 5
Switch(config-ecfm-srv)# continuity-check
Switch(config-ecfm-srv)# exit
Switch(config-ecfm)# exit
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ethernet cfm mep domain abc mpid 222 vlan 5
Switch(config-if-ecfm-mep)# exit

Configuring Ethernet CFM Crosscheck

To configure Ethernet CFM crosscheck, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# ethernet cfm mep crosscheck
start-delay delay
Step 3
Switch(config)# ethernet cfm domain
domain-name level level-id
Step 4
Switch(config)# service {ma-name | ma-number |
vpn-id vpn} {vlan vlan-id}
Step 5
Switch(config-ether-cfm)# mep mpid identifier
Step 6
Switch(config)# end
OL-25340-01
Purpose
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Display the configuration error list.
(Optional) Save your entries in the configuration file.
Purpose
Enters global configuration mode.
Configures the number of seconds that the device waits for
remote MEPs to come up before the crosscheck is started.
The range is 1 to 65535; the default is 30 seconds.
Defines a CFM domain, set the domain level, and enter
ethernet-cfm configuration mode for the domain. The
maintenance level number range is 0 to 7.
Define a customer service maintenance association name
or number or VPN ID to be associated with the domain, and
a VLAN ID, and enter ethernet-cfm-service configuration
mode.
• ma-name—A string of no more than 100 characters
that identifies the MAID.
• ma-number—A value from 0 to 65535.
• vpn-id vpn—Enter a VPN ID as the ma-name.
• vlan vlan-id—VLAN range is from 1 to 4094. You
cannot use the same VLAN ID for more than one
domain at the same level.
Define the MEP maintenance end point identifier in the
domain and service. The range is 1 to 8191.
Returns to privileged EXEC mode.
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring Ethernet CFM
63-11