Configuring A Port Mep - Cisco Catalyst 4500 Series Configuration Manual

Configuring Ethernet CFM
Switch(config-ecfm-srv)# mep mpid 34
Switch(config-ecfm-srv)# continuity-check static rmep
Switch# show ethernet cfm maintenance-points remote static
-------------------------------------------------------------------------
MPID Domain Name
-------------------------------------------------------------------------
23 abc
34 abc
Switch# show ethernet cfm errors
--------------------------------------------------------------------------------
MPID Domain Id
--------------------------------------------------------------------------------
34
23
Switch#

Configuring a Port MEP

A port MEP is a down MEP that is not associated with a VLAN and that uses untagged frames to carry
CFM messages. You configure port MEPs on two connected interfaces. Port MEPs are always configured
at a lower domain level than native VLAN MEPs.
To configure Ethernet CFM port MEPs, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# ethernet cfm domain
domain-name level level-id
Step 3
Switch(config-ecfm)# service {ma-name |
ma-number | vpn-id} port
Step 4
Switch(config-ecfm-srv)# mep mpid identifier
Step 5
Switch(config-ecfm-srv)# continuity-check
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
63-14
MA Name
test
test
MA Name
abc
test
abc
test
Chapter 63
Lvl Type Id
3 Vlan 5
3 Vlan 5
Mac Address
Reason
0000.0000.0000
RMEP missing
0000.0000.0000
RMEP missing
Purpose
Enters global configuration mode.
Defines a CFM domain, set the domain level, and enter
ethernet-cfm configuration mode for the domain. The
maintenance level number range is 0 to 7.
Defines a customer service maintenance association name
or number or VPN ID to be associated with the domain,
define a port MEP, and enter ethernet-cfm-service
configuration mode.
• ma-name—a string of no more than 100 characters that
identifies the MAID.
• ma-number—a value from 0 to 65535.
• vpn-id vpn—enter a VPN ID as the ma-name.
Defines the static remote maintenance end point identifier
in the domain and service. The range is 1 to 8191.
Enables sending and receiving of continuity check
messages.
Configuring Ethernet OAM and CFM
Mep-Up
No
No
Type Id
Lvl Age
Vlan 5
3 421s
Vlan 5
3 421s
OL-25340-01