Installing the refrigerator
➤ Lift up the door and remove it (fig. l, page 8).
➤ Undo the two screws on the door lock and remove the door lock (fig. m,
page 8).
➤ Place the door lock on the other side again and tighten it with the two
screws (fig. n, page 8).
➤ Undo the hinge pin (fig. o, page 8) and position it on the other side
(fig. p, page 8).
➤ Turn the door by 180° (fig. q, page 8).
➤ Place the door on the hinge pin.
➤ Replace the control panel and screw it down tightly.
6.9
Put on the door panel
A
NOTICE! Beware of damage
Only ever lay the refrigerator on its side and never on its back.
Otherwise the unit may be damaged.
The door panel has the following dimensions (fig. r, page 9):
RML9330/9331/9335: A
RML9430/9431/9435: B
Proceed as follows (fig. s, page 9):
➤ Remove the door trim carefully. It is only stuck on and held by small
hooks (A).
➤ Slide the new panel into the opening (B).
➤ Replace the door trim (B).
✓ The door trim is secure once it clicks into place.
If you have laid the refrigerator on its side to insert the panel:
➤ Wait a few minutes before you switch on the refrigerator.
22
RML9330 – RML9435
EN