Grundfos AQtap Service Instructions With Installation And Operating Instructions page 47

17.14 Completing steps after internal servicing
1. Connect the AQtap to the battery supply.
– Connect the red battery cable to the plus (+) pole (right side
of the battery).
– Connect the blue battery cable to the minus (-) pole (left side
of the battery).
– Torque = 4.0 ±0.05 Nm
Torque [Nm]
4.0 ±0.05
2. Close the cabinet.
1
2
2
3. Open the shut-off valve and power-on the AQtap.
4. Tap an amount of water until the AQtap is deaerated.
5. Check that the connections are tight.
1/On
0/Off
Subject to alterations.
47