Table of Contents
Advertisement
Configuration
October 2016
Verify by Gateway
To use the Wireless Gateway's integrated web interface, navigate to the Explorer > Status page as shown
in
Figure
properly.
Locate the device in question and verify all status indicators are good (green). It may take several
minutes for the device to join the network and be seen on the Gateway's integrated web interface.
Figure 4-11. Wireless Gateway Explorer Status Page
Verify with Field Communicator
Connect the Field Communicator as shown in
Removing the power module may cause the device to drop off the network.
Note
In order to communicate with a Field Communicator, the device must be powered by the power module.
To verify the device has joined the network, do the following:
1. From the Home screen, select Service Tools > Communications.
2. Select Join Status, and follow the instructions.
64
4-11. This page shows whether the device has joined the network and if it is communicating
Figure 4-6 on page
59. Do not remove the power module.
Reference Manual
00809-0100-4308, Rev BB
Configuration
Advertisement
Table of Contents
Troubleshooting
