High Gain Remote Antenna Option
October 2016
Appendix C
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 151
C.1
Safety messages
Procedures and instructions in this section may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential safety issues is indicated by a
warning symbol ( ). Refer to the following safety messages before performing an operation preceded
by this symbol.
When installing remote mount antennas for the wireless field device, always use established safety
procedures to avoid falling or contact with high-power electrical lines.
Install remote antenna components for the wireless field device in compliance with local and national
electrical codes and use best practices for lightning protection.
Before installing consult with the local area electrical inspector, electrical officer, and work area
supervisor.
The wireless field device remote antenna option is specifically engineered to provide installation
flexibility while optimizing wireless performance and local spectrum approvals.
To maintain wireless performance and avoid non-compliance with spectrum regulations, do not
change the length of cable or the antenna type.
If the supplied remote mount antenna kit is not installed per these instructions, Emerson
Management is not responsible for wireless performance or non-compliance with spectrum
regulations.
Be aware of overhead electrical power lines.
High Gain Remote Antenna Option
High Gain Remote Antenna Option
Reference Manual
00809-0100-4308, Rev BB
™
Process
151