Installing The Switch; Mounting The Switch In A 19-Inch Rack By Using Mounting Brackets - HP officeconnect 1910 series Getting Started Manual

Installing the switch

WARNING!
Before installing or moving the switch, remove the power cord.
You can install an HPE 1910 switch in a 19-inch rack, on a workbench, or on a wall.
Mounting the switch in a 19-inch rack by using
mounting brackets
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Verify that the rack is securely grounded and is stable.
2.
Select mounting brackets for the switch.
3.
The HPE 1910 8 switch uses Type-A mounting brackets, as shown in
The HPE 1910 8 PoE+ switch uses Type-B mounting brackets, as shown in
The HPE 1910 24 PoE+, 1910 24, and 1910 48 switches use Type-C mounting brackets, as
shown in
Attach the mounting brackets to both sides of the chassis with screws.
4.
NOTE:
Mounting brackets are used only for securing the switch to the rack. A rack shelf on the rack is
used to bear the switch weight.
Figure 1 Attaching Type-A mounting brackets to the switch
Figure 2 Attaching Type-B mounting brackets to the switch
Figure 3.
4
Figure 1.
Figure 2.