Removing The Camera From The Housing - Ikelite 6973.03 Instruction Manual

Removing the Camera from the Housing

1. Thoroughly dry housing.
2. Remove the housing back, see Step 3, Opening the Housing, Page 9.
3. Remove the Hotshoe from the camera mount.
4. Grab the thumbscrew with your thumb and index finger. Slowly and
gently pull the camera backward to separate from housing, Diagram D.
Continue pulling the camera backward and remove from housing. We
recommend doing this procedure on a desktop or solid flat surface to
avoid dropping the camera.
If you are finished using the housing, remove the Mounting Tray from
the camera bottom and slide it back into the Housing Mounting Plate,
then replace the Housing Back. For storage and travel, remove the back
o-ring and place in a small plastic bag. Place the bag inside the housing
and reattach the housing back.
Note: The Mounting Tray MUST be removed when changing a camera
battery or SD card.
Thumbscrew
14
Diagram D
Optional Dome Port 5516.15