Selecting Line Voltage; Connecting To Line Power - Fluke 5520a Operator's Manual

Multi-product

Hide thumbs Also See for 5520a:

Table of Contents

Selecting Line Voltage

There are four line voltage settings: 100 V, 120 V,

200 V, and 240 V (47 to 63 Hz). To check the

setting, note the voltage visible through the

window of the fuse compartment cover. To change

the line voltage setting, see the figure above.

To avoid shock hazard, connect the

factory supplied, three-conductor

power cord to a properly grounded

power outlet. Do not use a two-

conductor adapter or extension cord;

this will break the protective ground

connection.

Use the rear-panel ground terminal for

a protective grounding wire if there is

any question as to instrument earth

grounding.

The Calibrator comes with the line power plug

appropriate for the country to which it is shipped. If

you need a different plug, refer to Chapter 2 of the

5520A Operators Manual for a list and illustrations

of available plugs.

After you verify that the line voltage is set correctly

and that the correct fuse is installed, connect the

Calibrator to a properly grounded three-prong

outlet.

Warning

Table of Contents