Information; Safety Information - BMW i wallbox Installation Instructions Manual

Table of Contents

Advertisement

INFORMATION

Safety information

WARNING
Electrical danger.
The Wallbox must be installed, commissioned and serviced by suitably trained, qualified
and authorised electricians
standards and installation regulations.
Please note that an additional overvoltage protection may be required by vehicles or
national regulations.
Please refer to national connection and installation standards.
Only connect voltages and circuits in the right-hand connection zone (Ethernet, terminals
for control cables) which are safely isolated from dangerous voltages (for example adequate
insulation).
Before commissioning the device check that all screw and terminal connections are tight.
The termination panel cover must never be left opened without supervision. Fit the
termination panel cover when you leave the Wallbox.
Do not make any unauthorised changes or modifications to the Wallbox.
Repair work to the Wallbox is not permitted and may only be completed by the
manufacturer or a trained expert (Wallbox replacement).
Do not remove any identifiers such as safety symbols, warning instructions, rating plates,
labels or cable markings.
The Wallbox does not have its own mains switch. The residual-current-operated circuit
breaker and circuit breaker on the building insulation is used as a mains isolation device.
Only pull the charging cable out of the connector using the plug, not the cable.
Ensure that the charging cable is not mechanically damaged (kinked, jammed or run over)
and that the contact area does not come into contact with heat sources, dirt or water. 
Persons who, as a result of their training, skills and experience and their knowledge of the relevant
(1)
standards, can assess the work assigned to them and identify possible dangers.
CAUTION
5 safety rules:
Switch off on all poles and from all sources.
Secure to prevent it being switched on again.
Verify isolation from the supply.
Earth and short-circuit.
Cover neighbouring live parts and cordon off danger areas. 
who bear full responsibility for compliance with current
(1)
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents