Settings; Dip Switch Settings - BMW i wallbox Installation Instructions Manual

SETTINGS

DIP switch settings

Note
Changes to the DIP switch settings do not take effect until the Wallbox has been restarted.
Press the Service button for 1 second for this purpose or switch the supply voltage off and
on again.
Note
Switches which are not described below have no influence on the functions of the device.
28
DIP switches
The DIP switches are used to address and
configure the Wallbox and are located under the
termination panel cover.
DSW1 configuration, DIP switch up
DSW2 addressing, DIP switch down
DIP switch specimen illustration
The illustration shows the position of the DIP
switches for ON and OFF states to make the
process easier to explain.