Battery - TATA Motors TIAGO Owner's Manual

Hide thumbs Also See for TIAGO:
Table of Contents

Advertisement

MAINTENANCE
NOTE
Topping of the coolant should be
done in the auxiliary tank only.
Make sure that only TATA MOTORS rec-
ommended coolant is used. Mixing of
different coolants may harm your en-
gine's cooling system and its compo-
nents. Do not add extra inhibitors or ad-
ditives to the coolant. These can be
harmful and compromise the corrosion
protection of the engine coolant.
WARNING
The engine cooling system is pres-
surized, particularly when the en-
gine is warm. When opening the
cap, you could be scalded by hot
coolant spraying out. There is a risk
of injury.
Let the engine cool down before
opening the cap. Wear eye and
hand protection when opening the
cap. Open the cap slowly half a
turn to allow pressure to escape.
110
Windshield Washer Fluid Level
Check that there is washer fluid in the
tank. Refill it if necessary. Use a good
quality windshield washer fluid, diluted
with water as necessary.
NOTE
Do not use detergent or any other
additive in the windshield washer
reservoir. This can severely impair
visibility when sprayed on the wind-
shield, and can also damage your
vehicle's paint.
Do not operate washer motor with
no fluid in washer tank, washer
motor will be damaged
For location of Windshield Washer
Container and filling cap, please refer
respective
Engine
pages.

Battery

 Check the battery for electrolyte level
against the marking on the battery
outer case.
 Check the battery terminals for cor-
rosion (a white or yellowish powder).
To remove it, wash the terminals with
a solution of baking soda. It will bub-
ble up and turn brown.
 When this stops, wash it off with
plain water. Dry off the battery with a
cloth or paper towel.
 Coat the terminals with petroleum
jelly to prevent future corrosion.
 Use a proper wrench to loosen and
remove cables from the terminals.
 Always disconnect the negative (-ve)
Compartment
cable first and reconnect it last.
 Clean the battery terminals with a
terminal cleaning tool or wire brush.
Reconnect and tighten the cables,
coat the terminals with petroleum
jelly.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tiago 2017

Table of Contents