Guide For Use; Before Machine Start-Up; Installing And Unloading The Brush / Pad-Holder; Adjusting The Balance Of The Squeegee - Viper AS430C User Manual

ENGLISH

GUIDE FOR USE

WARNING
On certain parts of the machine are pasted some indicative signs:
－ DANGER
－ WARNING
－ CAUTION
－ CONSULTATION
When reading this manual, the operator must pay particular attentions to the symbols on these signs.
Under no circumstances shall these signs be covered. If they are damaged, please replace
immediately.

BEFORE MACHINE START-UP

INSTALLING AND UNLOADING THE BRUSH / PAD-HOLDER

NOTE
According to the type of floor to be cleaned, the machine may be installed with
brush (Figure3, A), or a pad-holder (Figure 3, B and C).
CAUTION ！
When manually installing or unloading the brush/pad-holder, first check if all the
switches are in the off position and lift the squeegee off the floor, only after which
can the brush or pad-holder be worked on. Furthermore, please put on protective
gloves to avoid being cut by fragments.
1. (Only applicable to AS430C and AS510C): make sure the
power cable (9) disconnecting the power supply and the
power switch (38) is at the disconnecting (O) condition.
2. Press down the handlebar (2) to lift the tank body (26).
3. Put the brush (A) or the pad-holder (B – C) under the case.
4. Use the handlebar (2) to lower the tank body (26) to come
into contact with the brush or pad-holder.
5. To install the brush/pad-holder automatically, turn the
power switch (38) to the "I" position and press down the
safety switch (1). Gently push the machine forward so as
to allow the belt wheel at the bottom of the tank body to
align with the brush or pad-holder which can then be
installed. Then release the safety switch. If necessary, repeat this procedure until the brush/pad-
holder is installed.
6. If Step 5 above proves to be difficult, use the manual method by following the arrow head (D) to
install the brush/pad-holder (as shown in Figure 3).
7. To automatically unload the brush/pad-holder, turn the power switch (38) to the "O" position. Use
the hand to hold the handlebar, and press the machine downwards until the guide wheel touches
the floor and the brush/pad-holder hangs in the air. Turn the power switch (38) to the "I" position,
and press down the safety switch to let the brush or pad-holder turn until the brush/pad-holder
drops to the floor.
8. If Step No. 7 above proves to be difficult, use the manual method by turning the brush/pad-holder
in the direction opposite to the normal turning direction, and it can be taken off. (as shown in
Figure 3)

ADJUSTING THE BALANCE OF THE SQUEEGEE

9. Install the squeegee and turn it tight with the handle (16). Then connect the vacuum tube (11) for
waste to the squeegee.
10. Adjust the squeegee through the adjusting handle (A) of the squeegee (see Figure 4).
1) If the mid-section of the rear squeegee strip, section B, has a gap with the floor or the
downward pressure is relatively light, adjust the handle in an anti-clockwise direction until the
whole length of the rear squeegee strip touches well with the floor. The front squeegee strip
should lightly touch the floor.
6
USER MANUAL
VF90015-EU
Figure 3