Troubleshooting; Machine Disposal - Viper AS430C User Manual

ENGLISH

TROUBLESHOOTING

Breakdown
The wiring not connected correctly or
bad wiring
Machine not
working
Bad brush motor
Carbon brush worn out
The wiring not connected correctly or
bad wiring
Vacuum motor
not working
Bad vacuum motor
Carbon brushes worn out
Bad ball valve
Bad solution valve
Little or no
Ball valve position in need of
solution flow
adjustment
Filter dirty.
Wastewater tank is full.
Vacuum tube for waste and squeegee
not properly connected
Float filter blocked or inlet blocked
Inadequate
Squeegee dirty or squeegee blade
Vacuum
worn and damaged
Recovery tank lid not properly turned
on, or the sealing strip of the water
tank damaged
Debris like fragments under the
squeegee blade
Squeegee
Squeegee
leaving marks
cracked, brittle.
Balance of squeegee not adjusted

MACHINE DISPOSAL

Use qualified crushing machine to destroy this machine.
Before destroying this machine, please take away and segregate the following materials which,
according to related laws and regulations, must be properly processed.
－ Brush/pad-holder
－ Plastic hoses and plastic components
－ Electrical and electronic components（*）
(*): Please contact the nearest VIPER Center (especially when scrapping of electrical and electronic
components is required).
14
USER MANUAL
Probable Causes
blade already
VF90015-EU
Remedies
Check the wiring or contact Viper
Distributor
Contact Viper Distributor
Contact Viper Distributor
Check the wiring or contact Viper
Distributor
Contact Viper Distributor
Contact Viper Distributor
Contact Viper Distributor
Contact Viper Distributor
When ball valve is in horizontal position,
the amount of solution flow is maximum
Clean the filter
Drain the water tank
Connect the Vacuum tube for waste and
the squeegee
Clean the float filter, check the float ball
Clean and check the squeegee
Refit on the lid properly, or change the
water tank sealing strip
Remove the fragments
worn,
Change the squeegee blade
Adjust the balance