Engine Oil Replacement; Oil Replacement, Engine; Replacement, Engine Oil - Kohler KDI-1903TCR Owner's Manual

Disconnect the negative wire (-) from the battery to avoid accidental engine starting.

5.1 Engine oil replacement

Important
• Place engine on level sur face to ensure accurate
measurement of oil level.
NOTE: Perform this operation with warm engine, to get a
better fluidity of the oil and get a full discharge of oil
and impurities contained in it.
1 - Loosen the oil filler cap A (Fig. 5.1).
2 - Remove the oil dipstick B.
3 - Remove the oil drain plug D and the gasket E
(the oil drain plug is on both sides of the oil sump).
4 - Drain oil in an appropriate container.
(For the exhausted
Par. 5.6 DISPOSAL and SCRAPPING).
5 - Replace gasket E.
6 - Tighten the drain oil plug D (tightening torque at 35 Nm).
7 - Add the type and amount of oil recommended
(Tab. 1.1 and Tab. 1.2).
8 - If the plug A is not accessible, use the oil
filler cap C.
Important
• Do not exceed the MAX level on the dipstick.
UM KDI 1903TCR_2504TCR _ cod. ED0053029490 - 2° ed_rev. 01
INFORMATION ABOUT REPLACEMENTS
Danger
oil disposal, refer to
A
Fig. 5.1
50 Nm
Fig. 5.2
A
Fig. 5.3
5
B
E
D
D
C
EN
29
Index