Table of Contents
Advertisement
Instruction Leaflet
Effective: Date 03/2006
rear of the relay. Carefully lay the screws aside for later
use.
SUPPORT THE PROTECTIVE RELAY FROM THE
FRONT SIDE WHEN THE SCREWS ARE
LOOSENED OR REMOVED. WITHOUT SUCH
SUPPORT, THE PROTECTIVE RELAY COULD
FALL OR THE PANEL COULD BE DAMAGED
Step 6: Mount the replacement unit. Read the "Mounting"
section of this document before attempting this.
Step 7: Replace the mounting screws.
MD-3000
IB02602001E
Step 8: Replace each wire at the correct terminal. Be sure
that each is firmly tightened. Remove temporary shorts on
incoming current transformers.
Step 9: Restore control power. Refer to the "Initial Power
Application" section of this document.
For more information visit:
www.EatonElectrical.com
Initial Release
Advertisement
Table of Contents
