Using The Remote Commander; Setting Menu - Sony J-10 Manual

4-3 Using the Remote Commander

Pull off the transparent film covering the battery parts.
4-3-1 How to Change the
Lithium Battery
1
Pull out the lithium battery case.
Pull the battery case toward you while releasing
the lock by plucking it with your fingernail.
2
Set lithium battery in the case so that the + symbol
on the battery is facing you.
3
Push the lithium battery case back into its original
position.
Notes on the Remote Commander
• If there is an obstacle between the Remote
Commander and the remote control detector, the
Remote Commander sometimes does not work
properly. Point the Remote Commander at the remote
control detector on the front side of the unit.
• The effective remote control area is limited. It
becomes easier to control the unit the closer you get
and if you point the Remote Commander directly at
the front of the unit.
• Change the battery when the Remote Commander
does not work properly.

4-3-2 Setting Menu

When a Remote Commander is used, WIRELESS
REMOTE CONTROL, extended menu item 213, must
to be set to ON. (It is set to OFF at the factory.)
(The following operation is an example of how
WIRELESS REMOTE CONTROL is switched from
OFF to ON.)
1
Select WIRELESS REMOTE CONTROL,
extended menu item 213, to display it.
The illustration shows the information displayed in
the time data display area and on the monitor
connected to the COMPOSITE (SUPER) output
connector, SDI (SUPER) output connector (for J-
10SDI/30SDI only) or DV connector.
Time data display area
Monitor screen
REMOTE INTERFACE
137
❉
213:WIRELESS-off
501
Items without ❉ are omitted.
4-7
Chapter 4 Playback (GB)