Sony J-10 Manual page 91

To set the end point
Holding down the STOP button, press the F FWD
button. The time code (LTC) value of the tape position
when the F FWD button was pressed is stored in
memory as the end point time data. When the end
point has been set, an asterisk (*) appears to the right
of the REPEAT indication in the time data display
area.
If no end point is set, the end of tape is automatically
specified as the repeat playback end point.
Notes
• Only LTC data can be stored in memory as end point
time data. Neither VITC nor CTL can be used as end
point data.
• If the start point has already been set, setting the end
point at a position before the start point results in
deletion of the start point data. (The time code value
of the end point cannot be smaller than that of the
start point.)
Beginning of tape End point
If you set the end point at a position before the start point,
Beginning of tape End point
the start point data will be deleted.
To execute a repeat playback
Press the PLAY button.
Indicates that the end point is set.
Start point End of tape
End of tape
To check the time code of the set start
point and end point
Hold down the STOP button and PLAY button
simultaneously. As long as you hold down both
buttons, the START indication, the start point time
code value, the END indication, and the end point time
code value are cyclically displayed in this order in the
time data display area.
To delete the set start point and end point
Press the EJECT button to eject the cassette. This
deletes both the start point and end point.
4-5
Chapter 4 Playback (GB)