Removing The Dr1 Side Panel - IBM DR550 Problem Determination And Service Manual

3. On the right door, rotate the upper and lower hinge pins and lift up each hinge
4. Grasp the door firmly with both hands and pull it away from the hinges.
5. On the left door, rotate the upper and lower hinge pins and lift up on each
6. Grasp the door firmly with both hands and pull it away from the hinges.
Replacing the DR1 rear doors
To replace the DR1 rear doors, follow these steps:
1. Grasp the left door firmly with both hands and align the slots in the door with
2. While holding the door firmly with one hand, push each of the hinge pins
3. Close the left rear door (it will be necessary to squeeze the blue-colored slide
4. Grasp the right rear door firmly with both hands and align the slots in the door
5. While holding the door firmly with one hand, push each of the hinge pins
6. Close the door and lock it using the DR1 door key.
Removing a DR1 side panel
The DR1 rack comes with side panels installed. To remove a side panel, follow
these steps:
1. Using the DR1 door key, unlock the side panels. Press out on both locking
Figure 22. Removing the DR1 side panel
2. Tilt the bottom of the side panel slightly toward you.
3. Lift the side panel away from the ridge on the top of the rack.
4. Repeat this procedure for the other side panel.
92
DR550 Version 4.5 Problem Determination and Service Guide
pin.
Note: This action will release the door from the hinges.
hinge pin.
Note: This action will release the door from the hinges.
the hinge pins.
down into the closed position.
bars together during this action to completely close the door).
with the hinge pins.
down into the closed position.
latches to release the latches.