GRAPHTEC GL840 Quick Start Manual page 19

(4) Move the cursor to the "Level" parameter next to the "Mode" parameter
and then press the [ENTER] key.
(5) The input box shown in the following screen is displayed. Select "20".
Use the and keys to move to the cursor to the second digit from the
right, and the and
key.
(6) When the screen changes to the following screen, move the cursor to the
button and then press the [ENTER] key.
(7) The screen returns to the TRIG menu screen. Press the [QUIT] key to
return the GL840 to the Free Running status.
(8) Press the [START/STOP] key to start data capture.
If the trigger condition has not been satisfied, the GL840 goes into the
"Armed" status as shown on the following screen.
When the trigger condition is satisfied, the recording is started after the
display is changed to the "Data capture SD card 1" .
Points to Remember
The trigger of this trigger function can be set easily from the "Easy trigger
setting" menu in the navigation displayed by pressing the [NAVI] key.
keys to change the value. Press the [ENTER]
Numerical value input box
Lower and upper limit for setting.
Waveform area for confirmation Lower
•Use the
values.
•Use the
digit.
•Use the [ENTER] key to enter the
value.
•Use the [QUIT] key to cancel the
setting.
and keys to change the
and keys to move the
18