Setup : How To Make The Settings - GRAPHTEC GL840 Quick Start Manual

2. Setup : How to Make the Settings

Make the settings required for data capture. Here we will make only those settings
that are minimum requirement. The other settings will be not changed from the
factory default settings.
Basic Setup Menu Operation
The , [ENTER], and [QUIT] keys are used to set the condition on the setup menu.
The current position of the cursor on the setup menu is displayed in green.
Use the keys to move the cursor. If you press the [ENTER] key at the cursor
position, a selection menu or a box of entering value for selected item is displayed.
If you press the [QUIT] key, the screen closes and the settings are canceled.
•
Examples of selection menu operations (AMP screen)
1. Use the keys to move
the cursor to the Input
parameter of CH 1 and then
press the [ENTER] key.
(Note: Select "DC" for voltage measurement, and "Humidity" for humidity measurement.)
Points to Remember
2. A selection menu is displayed
when the [ENTER] key is
pressed. Use the
to select "TEMP."
1. Press the [MENU] key to display the setup menu screen.
2. Set Input to "TEMP" and Sensor to "TC-T" for CH1,
and set Input to "DC" and Range to "1V" for CH2.
(1) Move the cursor to CH1 "Sensor" and select "TC-T" and then move it to
"Range" and select "100°C" .
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and
then move it to "Range" and select "1V."
3. Select "Off" for all the other channels.
(1) Using the procedure described above, select "Off" for CH 3 to CH 10.
Use the [CH GROUP] key to switch to the CH11 to CH20 group.
3. Press the [ENTERv key to
confirm your selection.
and keys
Select with ,
and [ENTER] key.
12