Attaching Top Joiner Bracket And Alcove Fixing Bracket To Alcove - Fisher & Paykel RS36W80 Installation Instructions Manual

7

ATTACHING TOP JOINER BRACKET AND ALCOVE FIXING BRACKET TO ALCOVE

Use M5 x 12 Socket head cap screws to connect the top joiner bracket to the alcove
1
fixing bracket.
– For 80" installation, use the upper slots of the alcove fixing bracket (refer to A).
– For 84" installation, use the lower slots of the alcove fixing bracket (refer to B).
A
B
Measure the width of your alcove. Mark a line in the center of the cavity, on the ceiling.
2
84" (2134mm)
72" (1829mm)
SCALE 1:10
For flush installation measure 4 1/4" (108mm) back from the front face of the adjacent
3
cabinetry doors (refer to C). Using #8 x 16 mush washer screws (4), align and fix the joiner
bracket to the center of the alcove (refer to D).
– Face 1 should be 4 1/4" (108mm) back.
– Face 2 should be lined up with the center of the alcove.
For proud installation, the joiner bracket should sit forward.
– Face 1 should be 4 1/4" (108mm) - x.
(x = distance the product sits proud).
– Face 2 should be lined up with the center of the alcove.
Loosely fix the screws into the center of each slot to enable adjustment in the joiner bracket.
WARNING!
Ensure anti tip brackets are fitted at this stage (refer to separate 'Installation instructions'
booklet supplied with your appliance).
IMPORTANT!
Door panels must be fitted to doors at this stage (refer to separate 'Installation
instructions' booklet supplied with your appliance).
WARNING!
Do not open doors.
4 1/4" (108mm) = flush installation
4 1/4" (108mm) - x = proud installation
x
At this stage connect to water and electrical supply as per the 'Installation instructions'
booklet supplied with your appliance.
WARNING!
Failure to follow the instructions can lead to serious injury or death.
C
D
Face 1
Face 2
5