Fisher & Paykel RS36W80 Installation Instructions Manual page 10

Remove the center* M10 x 65 Socket head cap screws from the base of the products
1
(refer to A)
*Remove the right screw from the left hinge product.
*Remove the left screw from the right hinge product.
Attach the bottom joiner bracket using M10 x 65 Socket head cap screws (refer to B).
2
A
For 80" products, cut center trim using the same method as instructed for side trims
3
(refer to separate 'Installation Instructions' booklet supplied with your appliance).
Mark out three locations for the spring clips along the center trim to match foam pad
4
locations on cabinet.
8
!0 PREPARING FOR CENTER TRIM
Insert right hand spring clip into the center trim channel (refer to C).
5
IMPORTANT!
Ensure the bottom of the right hand spring clip is located on the right hand side of the
channel.
Insert the left hand spring clip into the center trim channel (refer to D).
6
Before pushing the left hand spring clip all the way into the trim, squeeze the two spring
7
clips together and push home. You will hear the spring clips engage into the trim (refer to E).
Repeat for the remaining two locations on the center trim.
B
C
D E
CLICK!