Removing Hinge Bracket And Fitting Alcove Bracket - Fisher & Paykel RS36W80 Installation Instructions Manual

We have recommended starting with the left hinge product, then repeating the process on the right hinge product.
Removing hinge bracket
The following steps show how to remove the hinge bracket (non hinged side) and fit the
alcove bracket. This process is required on both left hinge and right hinge products.
Top trim
Ensure the distance between the end of the top trim and the side of the cabinet is no
1
greater than 1/4" (6mm). If distance is greater than 1/4" (6mm), loosen the pan head Phillips
screws at the back of the trim and shift the trim sideways to suit.
On the right hand side (when facing the product) loosen the M5 x 10 pan head Phillips top
2
trim attachment screws. Shift screws towards the center of the trim, (refer to A).
Remove the right hinge bracket from the left hinge product by unscrewing the countersunk
3
Phillips head screws with a Phillips head screwdriver (refer to B).
B
A
4
6

REMOVING HINGE BRACKET AND FITTING ALCOVE BRACKET

Fitting alcove bracket
Screw the front two M5 x 8 countersunk Phillips screws (refer to C). Check that the top face
4
of the front trim is parallel to the product.
Shift M5 x 10 pan head Phillips trim attachment screws into the slots in the alcove bracket,
5
(refer to D).
– If you are not satisfied that the front trim is parallel to the product, screw the jacking
screw supplied: M5 x 12 Socket head cap screw (refer to E) to adjust the trim position.
Once you are satisfied that the front trim is parallel to the product, secure the alcove bracket
6
with the third countersunk screw (refer to F).
C
D
F
E
Repeat process of removing hinge bracket and fitting alcove bracket on the right
hinge product.