Making Network Connections; Twisted-Pair Devices - Edge-Core ECS3510-28F Installation Manual

4
M
The ECS3510-28F switch is designed to provide high-speed Internet access to
individual subscribers through its 100BASE-FX single-fiber downlink
connections. Four combination 1000BASE-T/SFP ports provide the uplink
connection from the switch to other switches or routers at the central office.
T -P
WISTED AIR
Each device requires an unshielded twisted-pair (UTP) cable with RJ-45
connectors at both ends. Use Category 5, 5e or 6 cable for 1000BASE-T
connections, Category 5 or better for 100BASE-TX connections, and Category 3
or better for 10BASE-T connections.
C G
ABLING UIDELINES
The RJ-45 ports on the switch support automatic MDI/MDI-X pinout
configuration, so you can use standard straight-through twisted-pair cables to
connect to any other network device (PCs, servers, switches, routers, or hubs).
See Appendix B for further information on cabling.
C
AUTION
will damage the switch. Use only twisted-pair cables with RJ-45
connectors that conform to FCC standards.
N
AKING
D
EVICES
Do not plug a phone jack connector into an RJ-45 port. This
:
ETWORK
– 43 –
C
ONNECTIONS