| Installing the Switch
C
3
HAPTER
Mounting
If also installing an RPU, mount it in the rack below the other devices.
5.
D
S
ESKTOP OR
The switch includes four pre-installed rubber feet for desktop or shelf mounting.
To mount devices on a horizontal surface, follow these steps:
Attach the four adhesive feet to the bottom of the first switch.
1.
Figure 10: Attaching the Adhesive Feet
Set the device on a flat surface near an AC power source, making sure there
2.
are at least two inches of space on all sides for proper air flow.
If installing a single switch only, go to
3.
page
40.
If installing multiple switches, attach four adhesive feet to each one, then
4.
place each device squarely on top of the one below, in any order.
If also installing an RPU, place it close to the stack.
5.
M
HELF
OUNTING
"Connecting to a Power Source" on
– 38 –