Operation Menu - Panasonic AJ-DCP Operating Instructions Manual

Setup Menus

OPERATION menu

Item
Superimposed
No.
display
100 SEARCH SPEED
101 SHTL MAX
102 FF. REW MAX
103 AUDIO MUTE
104 REF ALARM
105 STOP MODE
106 HUMID OPE
107 WIDE MODE
108 AUTO REW
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
For setting the speed at which the tape is to be decelerated when the
search switch on the front panel has been pressed.
0000 X4.1 0: 4.1a normal tape speed
0001 X8.4 1: 8.4a normal tape speed
For setting the maximum speed in the shuttle mode when the external
controller connected to the 9-pin remote connector is used.
0000 X8.4 0: 8.4a normal tape speed
0001 X16 1: 16a normal tape speed
2: 32a normal tape speed
0002 X32
For setting the maximum fast forward and rewind speed.
0000 X16 0: 16a normal tape speed
0001 X32 1: 32a normal tape speed
0002 X60 2: 60a normal tape speed
<Note>
When the 50M mode has been selected as the menu item No.007 (SYS
FORMAT) setting, the tape will run at 32a the normal tape speed even if
60a has been selected.
For setting the status until the audio signals are output when the unit has
been transferred from the stop mode or search mode to play mode. (This
item functions only with PCM audio signals.)
0000 OFF 0: It takes a shorter time until the audio signals are output.
0001 ON 1: The audio signals are stabilized before they are output.
For setting whether a warning is to be displayed when the reference video
signal has not been connected.
0000 OFF 0: No warning is displayed.
0001 ON 1: A warning is displayed (the stop button flashes when there is a warning).
For setting the mode of the digital circuit in the stop mode.
0000 REC 0: The digital circuit is set to the REC system. It takes a shorter time for
operation to transfer to the REC mode.
In this case, the E-E mode is established regardless of the position of the
TAPE/EE switch.
0001 PB 1: The digital circuit is set to the PB system. It takes a shorter time for
operation to transfer to the playback mode.
For setting whether to ignore condensation when it has formed and
continue with operation.
0000 OFF 0: Unit does not continue to operate when condensation has formed.
0001 ON 1: Unit continues to operate when condensation has formed in which case it
cannot be guaranteed that the unit will operate normally.
<Note>
Due to the possibility that the tape may be damaged, this item should
normally be set to 0 (no operation).
For setting whether to perform recording in the wide mode.
0000 WIDE 0: Recording is performed in the wide mode.
0001 NORMAL 1: Recording is performed in the 4:3 normal mode.
For setting whether to automatically rewind the tape to the beginning when
the tape end has been detected by a recording, playback or search
operation.
0000 OFF 0: The tape is not rewound.
0001 ON 1: The tape is rewound to its beginning.
30
Description of setting