Superimposed Screens - Panasonic AJ-DCP Operating Instructions Manual

Superimposed Screens

When the unit's MONITOR OUT connectors have
been connected to a TV monitor, the control signals,
time codes, etc. can be displayed as abbreviations on
the TV monitor screen.
This display can be set to ON or OFF by setting setup
menu item No.002. (See page 29)
TV monitor
TCR : : :
Abbreviations
CTL (control signal)
TCR (playback value of time code)
UBR (playback value of user's bit)
REMAIN (remaining tape)
Display characters
The background of the superimposed display
characters can be changed by setting setup menu
item No.006 "CHARA TYPE." (See page 29)
TCR : : :
TV monitor
No display
: Normally, no display.
P : Flashes when the DC
supply voltage has
dropped.
S : Flashes in "FAN STOP"
status.
L : Flashes in "LOW RF"
status.
N : Flashes in "NO RF"
status.
T T C C R R : : : : : :
TV monitor
21
Display position
The position of the superimposed display characters
can be changed by setting setup menu items No.004
"CHARA H-POS" and No.005 "CHARA V-POS."
(See page 29)
TCR : : :
TV monitor
<Notes>
When the PAGE button and DATA+ button or DATA–
button are pressed, the counter display appears
temporarily on the TV monitor while these buttons are
held down to enable the setting to be checked.
Even while the PAGE button is pressed, the settings
can be performed using the DATA+ button or DATA–
button while the actual status is checked.
TCR : : :
TV monitor