Basic Menu - Panasonic AJ-DCP Operating Instructions Manual

Setup Menus

BASIC menu

Item
Superimposed
No.
display
000 LOCAL ENA
001 TAPE TIMER
002 SUPER
003 DISPLAY SEL
004 CHARA H-POS
005 CHARA V-POS
006 CHARA TYPE
007 SYS FORMAT
008 PB FORMAT
The underlining indicates the factory setting.
<Notes>
O If the PAGE button and DATA+ button or DATA– button are pressed when the CHARA H-POS or
CHARA V-POS item has been set, the counter display appears temporarily while this button is held
down to enable the setting to be checked.
Even while the PAGE button is pressed, the settings can be performed using the DATA+ button or
DATA– button while the actual status is checked.
Setting
Superimposed
No.
display
For setting the switches which can be operated on the front panel when the
REMOTE/LOCAL switch has been set to REMOTE.
0000 DIS 0: None of the switches can be operated.
0001 ST&EJ 1: Only the STOP and EJECT switches can be operated.
0002 ENA 2: All operations are possible except for the COUNTER button and RESET
button.
For setting the CTL counter to the 12-hour or 24-hour display system.
0000 ±12h 0: 12-hour display system
0001 24h 1: 24-hour display system
For setting whether to display the time code, etc. onto the video monitor
output by superimposing it.
0000 OFF 0: Superimposed data is not displayed.
0001 ON 1: Superimposed data is displayed.
For setting what is to be displayed by superimposing onto the video monitor
output.
0000 TIME 0: Only the time is displayed.
0001 T&STA 1: The time and operation status are displayed.
0002 T&R 2: The time and amount of remaining tape are displayed.
0003 T&S&R 3: The time, operation status and amount of remaining tape are displayed.
0000 0 For setting the character position in the horizontal direction for the
superimposed display.
0004 4
0008 8
0000 0 For setting the character position in the vertical direction for the
superimposed display.
A setting from 0 to 18 is valid in the T&S&R mode (3-line display).
0022 22 A setting from 0 to 20 is valid in the T&STA mode or T&R mode (2-line
display).
For setting the type of superimposed display and menu display.
0000 WHITE 0: White characters are displayed on a black background.
0001 W/OUT 1: White characters with black borders are displayed.
For setting the unit's recording and playback format.
0000 50M 0: 50 Mbps mode
0001 25M 1: 25 Mbps mode
For setting the format during tape playback.
0000 MANUAL 0: Setting is based on the setting selected for menu item No.007 (SYS
FORMAT).
0001 AUTO 1: Setting is based on the format recorded on the tape.
29
Description of setting