Ricoh Aficio SP 100SF Service Manual page 196

6. Troubleshooting
Timeout Length
BT (Busy Tone) Detecton
BT Setting
Comm Settings
RTN Rate
V34 Modem
V17 Modem
V34 Settings
194
Sets the length of the time-out for the 1st dial tone
connection. The machine waits the time specified
below for a dial tone, and then disconnects
automatically if no dial tone is detected.]
• Default: 10 sec.
• 10 to 30 sec.
Sets busy tone detection.
• On (Default)
• Off
Sets the error ratio for error judgment on data
received in non-ECM mode.
• Default: 11%
• Range: 11% or 14%
A V34 modem cannot operate if use of a V34
modem is prohibited with the setting below.
Therefore, if 33.6 is selected for the TX/RX Speed
setting in the User Tool V17 must be selected.
• Permitted. (Default) Use of V34 modem is
allowed.
• Prohibited. Use of V34 modem not allowed.
A V17 modem cannot operate if use of a V17
modem is prohibited with the setting below.
Therefore, if 14.4 is selected for the TX/RX Speed
setting in the User Tool V29 must be selected.
• Permitted. (Default) Use of V34 modem is
allowed.
• Prohibited. Use of V34 modem not allowed.