Drinking Water Connection; Warm Water Connection - Gaggenau DI261 Instruction Manual

en
Installation and connection

Drinking water connection

1.
Fasten the drinking water connection to the tap
according to the installation instructions using
the enclosed parts.
Ensure that the drinking water connection is not
kinked, crushed or twisted.
2.
When replacing the appliance, always use a new
water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure:
connect pressure-reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water.
Hot water:
Maximum temperature 60 °C.
42

Warm water connection *

* depending on the features of your dishwasher
Wa r m wa t e r c o nnec t i o n
The dishwasher can be connected to cold or hot water
up to max. 60 °C. Connection to hot water is
recommended if the hot water can be supplied by
energetically favourable means and from a suitable
installation, e.g. solar heating system with circulation
line. This will save energy and time. The "Hot water"
setting allows you to adjust your dishwasher optimally to
operation with hot water. It is recommended to have a
water temperature (temperature of the incoming water)
of at least 40 °C and no more than 60 °C. It is not
recommended to connect the appliance to hot water if
the water is supplied from an electric boiler.
To change the setting:
1.
Open the door.
Switch on ON/OFF switch (.
2.
3. Press Info button {8 for 3 seconds until the
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing the button > )* until water
connection appears of the display window at the top
@.
5.
Make the setting with setting buttons + -X.
6. Press and hold the Info button {8 for 3 seconds.
The chosen setting has now been stored.